Order Flags at Theodora's Flag Shop
A B C
D E F
G H I
J K L
M N O
P Q R
S T U
V W X
Y Z ?
PreviousNextSearchContentsONETLink to this SiteAbout

Spanish Simplified Chinese French German Russian Hindi Arabic Portuguese
CODE: 692.682-010Buy the DOT:Download
TITLE(s): ANKLE-PATCH MOLDER (boot & shoe)

Operates electrically heated machine to mold plastic trademark ankle patch onto quarters for sneakers: Pours liquid plastic into feeder tank. Lifts plate cover, equipped with two die openings for simultaneous molding of right and left quarters. Slides dies into holders, tightens screws and replaces plate, using wrench. Starts machine and presses button to blow air through sprue holes in dies to clear openings. Brushes silicone on dies to prevent sticking. Positions right and left quarters over die openings on plate with edges against guide pins. Presses buttons to lower rams onto quarters, inject plastic to fill dies, and mold patches. Examines molded pieces for defects, such as insufficient plastic, lack of adhesion to cloth, discoloration, or unclear imprint, and rejects defective pieces. Cleans adhering plastic from die grooves and sprue holes, using metal pick. Adjusts rheostat to vary heat setting, according to size of die and to correct defects.
GOE: 06.02.02 STRENGTH: L GED: R3 M2 L3 SVP: 4 DLU: 77

Previous Next Contents ONET About


CODE: 692.682-010 Buy the DOT:Download TITLE(s): ANKLE-PATCH MOLDER (boot & shoe)

Operates electrically heated machine to mold plastic trademark ankle patch onto quarters for sneakers: Pours liquid plastic into feeder tank. Lifts plate cover, equipped with two die openings for simultaneous molding of right and left quarters. Slides dies into holders, tightens screws and replaces plate, using wrench. Starts machine and presses button to blow air through sprue holes in dies to clear openings. Brushes silicone on dies to prevent sticking. Positions right and left quarters over die openings on plate with edges against guide pins. Presses buttons to lower rams onto quarters, inject plastic to fill dies, and mold patches. Examines molded pieces for defects, such as insufficient plastic, lack of adhesion to cloth, discoloration, or unclear imprint, and rejects defective pieces. Cleans adhering plastic from die grooves and sprue holes, using metal pick. Adjusts rheostat to vary heat setting, according to size of die and to correct defects.
GOE: 06.02.02 STRENGTH: L GED: R3 M2 L3 SVP: 4 DLU: 77


© 1995 - 2015 Photius Coutsoukis and Information Technology Associates (All Rights Reserved). Revised 26-May-03