Order Flags at Theodora's Flag Shop
A B C
D E F
G H I
J K L
M N O
P Q R
S T U
V W X
Y Z ?
PreviousNextSearchContentsONETLink to this SiteAbout

Spanish Simplified Chinese French German Russian Hindi Arabic Portuguese
CODE: 617.480-010Buy the DOT:Download
TITLE(s): JOB SETTER, SPLINE-ROLLING MACHINE (machine shop)

Sets up automatic spline roll-forming machines to cold-form splines on gear shafts according to machine setup instructions and knowledge of operational capabilities of machine, using handtools and gauges: Places shims to position die-racks (used to form teeth on splines by pressure-rolling action) at specified height and verifies position with micrometer. Turns knob to adjust vernier gauges and obtain specified spacing of die mounts. Places die-racks in mounts and clamps racks in position. Places spline blank between machine centers and positions machine tailstock to accommodate length of workpiece. Starts and cycles machine to verify operation specified. Inspects trial run splines for conformance to specifications, using micrometer and gauges. Adjusts machine to correct faulty setup if splines do not meet specifications. May set up roll-forming machines to cold-form threads on gear shaft and be designated Job Setter, Thread-Rolling Machine (machine shop).
GOE: 06.01.02 STRENGTH: M GED: R3 M2 L3 SVP: 5 DLU: 77
ONET CROSSWALK: 91314 Rolling Machine Setters and Set-Up Operators, Metal and Plastic

Previous Next Contents ONET About


CODE: 617.480-010 Buy the DOT:Download TITLE(s): JOB SETTER, SPLINE-ROLLING MACHINE (machine shop)

Sets up automatic spline roll-forming machines to cold-form splines on gear shafts according to machine setup instructions and knowledge of operational capabilities of machine, using handtools and gauges: Places shims to position die-racks (used to form teeth on splines by pressure-rolling action) at specified height and verifies position with micrometer. Turns knob to adjust vernier gauges and obtain specified spacing of die mounts. Places die-racks in mounts and clamps racks in position. Places spline blank between machine centers and positions machine tailstock to accommodate length of workpiece. Starts and cycles machine to verify operation specified. Inspects trial run splines for conformance to specifications, using micrometer and gauges. Adjusts machine to correct faulty setup if splines do not meet specifications. May set up roll-forming machines to cold-form threads on gear shaft and be designated Job Setter, Thread-Rolling Machine (machine shop).
GOE: 06.01.02 STRENGTH: M GED: R3 M2 L3 SVP: 5 DLU: 77
ONET CROSSWALK: 91314 Rolling Machine Setters and Set-Up Operators, Metal and Plastic


© 1995 - 2015 Photius Coutsoukis and Information Technology Associates (All Rights Reserved). Revised 26-May-03